Dell PowerEdge M IO Aggregator Manual de usuario descargar pdf (Pagina 21)

Defaults

8 seconds

Command Modes

FCOE MAP

Command History

Version 9.3(0.0)

Related Commands

• fcoe-map

•

show fcoe-map

interface vlan

Create a dedicated VLAN to be used to send and receive Fibre Channel traffic over FCoE links.

Syntax

interface vlan vlan-id

Parameters

vlan-id = Enter a number as the VLAN Identifier. The range is 1 to

4094.

Defaults

Not configured.

Command Modes

CONFIGURATION

Command History

Version 9.3(0.0)

Usage Information

You must configure a separate FCoE VLAN for each fabric to which

FCoE traffic is forwarded.

When you apply an FCoE map to a server-facing Ethernet port, the

port is automatically configured as a tagged member of the FCoE

VLAN.

For more information about VLANs and the commands to configure

them, refer to the Virtual LAN (VLAN) Commands section of the

Layer 2 chapter.

Example (Single Range)

Dell(conf)#interface vlan 10

Dell(conf-if-vl-10)#

Related Commands

• fcoe-map

•

show fcoe-map

keepalive

Enable FIP keepalive message monitoring (if disabled).

Syntax

Keepalive

To remove FIP keepalive monitoring from an FCoE map, enter the

keepalive command.

Parameters

None

Defaults

Enabled on Ethernet and FC interfaces.

Command Modes

FCOE MAP

Command History

Version 9.3(0.0)

Usage Information

Use FIP keepalive (FKA) messaging to detect if the other FCoE

devices are reachable.

Related Command

• fcoe-map

•

show fcoe-map

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 36 37

Comentarios a estos manuales

Sin comentarios

Dell PowerEdge M IO Aggregator Manual de usuario Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Dell PowerEdge M IO Aggregator