Dell PowerVault 0JC276A02 Manual de usuario

www.dell.com | support.dell.comGetting Started With Your PowerVault™ 124TZačínáme se systémem PowerVault™ 124T Démarrage de votre PowerVault™ 124TZum

Configure el PowerVault 124T. La dirección IP predeterminada es 192.168.20.128.Para el Administrador, la contraseña predeterminada para el panel front

Information in this document is subject to change without notice. © 2006 Dell Inc. All rights reserved. Reproduction in any manner whatsoever without

CAUTION: Before performing the following procedure, read and follow the safety instructions and important regulatory information in your PowerVault

Unpack your system and accessories. Save all shipping materials in case you need them later. (Your system may not include all of the accessories shown

Install the PowerVault 124T in a rack. See your rack installation documentation for instructions on installing your PowerVault 124T in a rack. For mor

Establish the SCSI and network connections. Connect the SCSI cable (2) and terminator (3) if the unit is at the end of the SCSI bus. Connect an Ethern

Connect the system to power. NOTE: Be certain that the host server is powered off before connectingthe autoloader.Connect the system's power cabl

Verify robot/drive seen by operating system. Microsoft® Windows®: Under Device Manager, an unknown media changer should be present. Under Tap e Dri ve

Configure the PowerVault 124T. The default IP address is 192.168.20.128.The default password for the front panel is 000000 for Administrator, and 1111