Dell KVM 4322DS Manual de usuario descargar pdf (Pagina 39)

Installationxxx | xxx29

second power socket on the rear of the RCS, and plug the other end into a

different power source.

NOTE: Plug the redundant power supplies into separate branch circuits to

provide additional redundancy in the event one external AC power source

should go away.

8 (Optional) Connect the virtual media devices or smart card readers to any

of the USB ports on the switch.

NOTE: For all virtual media sessions, you must use a USB2 or USB2+CAC

SIP.

Connecting a SIP

To connect a SIP to each server:

1 Locate the SIPs for your RCS.

2 If you are using a PS/2 SIP connection, attach the color-coded ends of the

SIP cable to the appropriate keyboard, monitor, and mouse ports on the

first server you will be connecting to this RCS. If you are using a USB

connection, attach the plug from the SIP to the USB port on the first server

you will be connecting to this RCS.

3 To the RJ-45 connector on the SIP, attach one end of the CAT 5 cabling

that will run from your SIP to the RCS. See Figure 2.9.

4 Connect the other end of the CAT 5 cable to the desired Avocent Rack

Interface (ARI) port on the back of your RCS.

5 Repeat steps 2-4 for all servers you wish to attach.

NOTE: Power down the RCS before servicing. Always disconnect the jumper

cord from the power source.

NOTE: In addition to Dell SIPs, the RCS may also be connected to devices

using Avocent IQ modules, including Sun and Serial IQ modules.

Figure 2.9: SIP Connection

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 187 188

Sin comentarios

Dell KVM 4322DS Manual de usuario Pagina 39