Dell PowerEdge 2600 Manual de usuario descargar pdf (Pagina 6)

1-4 Information Update

www.dell.com | support.dell.com

RAID Controllers

Installing RAID Controllers

Install Dell™ PowerEdge™ Expandable RAID Controller (PERC) 3/DC and PERC 3/QC controller

cards in PCI-X expansion slots 2 through 5. Do not install PERC 3/DC and PERC 3/QC controller

cards in slots 6 and 7. Expansion cards with older PCI technology might overload the newer

133-MHz PCI-X slots (slots 6 and 7), which have a lighter signal load due to a shorter bus and only

one slot on the bus.

NOTE: "Overload" in this context refers to the signal load, not the power load. All the PCI slots receive

equal power from the same source.

See your

Installation and Troubleshooting Guide

for information about installing expansion cards.

Configuring RAID Controllers

NOTICE: Changing the configuration of the ROMB controller on the boot drive by mistake can result in

clearing the operating system configuration.

If ROMB is enabled and one or more PERC 3/DC or PERC 3/QC RAID controllers are installed in

the system, do not change the configuration of the ROMB controller on the boot drive by mistake.

When you access the RAID controller setup functions by pressing <Ctrl><m> during startup,

the ROMB boot drive is listed as the default controller. Be careful to select the correct RAID

controller before making any logical drive configuration changes.

Novell NetWare 6.0

USB Driver Issue

Systems running NetWare 6.0

with Support Pack 1 that have an attached USB keyboard can lock

up when the

reset server

command is run. Use the updated

UHC1DRV.NLM

file (version 1.01,

dated December 12, 2001, or a later version) on the

Dell OpenManage Server Assistant

to resolve this issue.

1 2 3 4 5 6 7 8 9 10 11 ... 51 52

Sin comentarios

Dell PowerEdge 2600 Manual de usuario Pagina 6