Dell PowerEdge RAID Controller S100 Manual de usuario descargar pdf (Pagina 35)

Hardware Installation

Connect Physical Disks to the PERC S300 Adapter

WARNING:

Critical system components might be damaged if the installer is not

properly grounded to prevent electrostatic discharge (ESD).

NOTE:

Use either the standard power connector or, if available on the power

supply, a SATA/SATA II power connector. Do not use both.

NOTE:

You can view the physical disk LEDs on a system that uses a PERC S300

controller by removing the front panel from the system.

NOTE:

The controller supports a feature that staggers the spinup of each physical

disk sequentially. This allows enough time between physical disk starts to prevent

the power supply from overloading.

Install the physical disks into the system.

Connect a multiple-connector cable from the physical disks (or from the

backplane) to the controller.

NOTE:

If the system contains a PERC S300 controller and has a backplane with hot-

swap capability, the cables cannot be inserted directly into the physical disks. The

physical disks (within their carriers) are inserted and seated in the backplane.

A cable from the backplane is then connected to the PERC S300 controller.

Complete the Hardware Installation

After the

controller and cables are installed, perform the following steps:

Make sure that the wire bundles and cables inside the system are not

twisted. Make sure they do not interfere with fans, power supplies, heat

sinks, or electrical devices.

Replace the cover of the system. See your system’s

Hardware Owner’s

Manual

User’s Guide

for more information on closing the system.

Reconnect the power cable(s) and network cables, and then turn on the

system.

A5_bk0.book Page 35 Thursday, February 10, 2011 8:34 PM

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 109 110

Sin comentarios

Dell PowerEdge RAID Controller S100 Manual de usuario Pagina 35