Dell Dimension 8300 Manual de usuario descargar pdf (Pagina 40)

The following table shows Integrated Devices (Legacy Select Options) option information.



The following table shows Power Management option information.



The following table shows System Security option information.



Boot Sequence

This feature allows you to change the boot sequence for devices.

Changing Boot Sequence for the Current Boot

You can use this feature, for example, to tell the computer to boot from the CD drive so that you can run the Dell Diagnostics on the ResourceCD, but you must

set the computer to boot from the hard drive when the diagnostic tests are complete.

1. Turn on (or restart) your computer.

2. When the blue DELL logo appears, press <F2> immediately.

If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft Windows desktop. Then shut down your

computer and try again.

The Boot Device Menu appears, listing all available boot devices. Each device has a number next to it.

3. At the bottom of the menu, enter the number of the device that is to be used for the current boot only.

Changing Boot Sequence for Future Boots

1. Enter the system setup program.

2. Use the arrow keys to highlight the Boot Sequence menu option and press <Enter> to access the pop-up menu.

3. Press the up- and down-arrow keys to move through the list of devices.

4. Press the spacebar to enable or disable a device (enabled devices have a checkmark).

5. Press plus (+) or minus (–) to move a selected device up or down the list.

Cache Size

Displays cache size.

Option

Function

Sound

Turns the integrated sound off and on. The default is On.

Network Interface Controller

Turns the network interface controller off and on. The default is On.

Mouse Port

Turns the mouse port off and on. The default is On.

USB Emulation

Turns USB emulation off and on. The default is On.

USB Controller

Turns the USB controller off and on. The default is On.

Serial Port 1

Sets serial port options and turns the port off and on. The default is Auto.

Parallel Port

Displays parallel port settings when <Enter> is pressed. The default mode is PS/2 and the I/O address default is 378h.

Diskette Interface

Sets diskette interface options. The default is Auto.

PC Speaker

Turns the PC speaker off and on. The default is On.

Primary Video Controller

Sets the primary video controller. The default is AGP.

Option

Function

Suspend Mode

Displays the suspend state used by the computer. The default is S3.

AC Power Recovery

Enables AC power recovery to occur. The default is Off.

Low Power Mode

Minimizes power use when the computer is off. The default is Disabled.

Option

Function

Password

Status

Locks and unlocks the password option. The default is Unlocked.

System

Password

Enables and disables the system password. The default is Disabled.

Setup Password

Enables and disables the setup password. The default is Disabled.

POST Hotkeys

Selects key that are active during POST. The default is F2 and F12.

PXE BIS Default

Policy

Specifies how the computer will respond to boot integrity services authentication requests when no certificate has been installed. When

set to Deny (the default), this request is rejected. The request is accepted when set to Accept.

NOTE: Write down your current boot sequence in case you want to restore it.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 48 49

Comentarios a estos manuales

Sin comentarios

Dell Dimension 8300 Manual de usuario Pagina 40

Comentarios a estos manuales

Relacionado con productos y manuales para Ordenadores Dell Dimension 8300