Dell Precision 390 Manual de usuario Pagina 129

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 138
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 128
Diskettesubsystemresetfailed Dell Diagnostics (see Dell Diagnostics).
Diskettewriteprotected Slide the write-protect notch to the open position.
Drivenotready Put a floppy disk in the drive.
GateA20failure See Lockups and Software Problems.
Hard-diskconfigurationerror
Hard-diskcontrollerfailure
Hard-diskdrivefailure
Hard-diskdrivefailure
See Drive Problems.
Insertbootablemedia Insert a bootable floppy disk or CD.
Invalid configuration information -pleaserunSETUPprogram Enter system setup (see Entering System Setup) and correct the
computer configuration information.
Keyboardfailure See Keyboard Problems.
Memory address line failure at address, read value expecting value See Lockups and Software Problems.
Memoryallocationerror
1. Turn off the computer, wait 30 seconds, and then restart the computer.
2. Try to run the program again.
3. If the error message appears again, see the software documentation for additional troubleshooting suggestions.
Memory data line failure at address, read value expecting value
Memory double word logic failure at address, read value expecting value
Memory odd/even logic failure at address, read value expecting value
Memory write/read failure at address, read value expecting value
MemorysizeinCMOSinvalid
See Lockups and Software Problems.
Nobootdeviceavailable
l If the floppy drive is your boot device, ensure that a bootable floppy disk is in the drive.
l If the hard drive is your boot device, ensure that the cables are connected and that the drive is installed properly and partitioned as a
boot device.
l Enter system setup (see Entering System Setup) and ensure that the boot sequence information is correct.
No boot sector on hard-diskdrive Enter system setup (see Entering System Setup) and ensure that the computer configuration
information for the hard drive is correct.
Vista de pagina 128
1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 137 138

Comentarios a estos manuales

Sin comentarios