Dell S300WI Guía de usuario descargar pdf (Pagina 39)

Using Your Projector 39

NOTE: OSD warning messages - low battery

• The Low Battery warning message pops up when the battery voltage is

lower than 2V. At this condition, the pen can still work about 1~2 hours.

• The pen will be disabled when the battery voltage is lower than 1.8V.

NOTE: OSD warning messages - out of range

The situations below may cause the pen sensor out of range:

• The pen doesn't point toward the screen.

• The pen is too far away from the screen.

• The projector brightness is too low for detection.

NOTE: Combinations of buttons

• Left + Function: The Pen Information menu appears on the screen.

• Right + Function: The Set Function menu appears on the screen. Use

Left/Right to move up/down and use Function to enter/apply.

• When Toggle is selected in the Set Function menu, press the Function

button to select Normal/Draw/Stable mode.

NOTE: Interactive pen cannot support Windows Mouse property function

"Switch primary and secondary buttons".

2 Left This button acts like the left click button of a

mouse.

3 Function Functions available are listed in OSD Menu "Set

function" (see page 64).

NOTE: Double click Function button will

act as Undo, if supported by the software.

4 LED indicators Two LED indicators are available: Green and

Amber (see on "Interactive Pen LED Guiding

Signals" on page 110).

5 Right This button acts like the right click button of a

mouse.

6 Reset Press to reset the interactive pen configuration.

Downloaded From projector-manual.com DELL Manuals

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 126 127

Sin comentarios

Dell S300WI Guía de usuario Pagina 39