Dell Dimension E520 El manual del propietario Pagina 95

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 162
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 94
Removing and Installing Parts 95
1
Follow the procedures in "Before You Begin" on page 59.
2
Remove the drive panel (see "Removing the Drive Panel" on page 83).
3
Gently slide the drive into place until you feel a click or feel the drive securely installed.
NOTE: If you are installing a new floppy drive rather than replacing a drive, remove the drive panel insert where
you want the drive to be installed, insert the shoulder screws located in the back of the drive panel insert into the
drive, and then slide the drive back into place.
4
Attach the power and data cables to the floppy drive.
5
Connect the other end of the data cable to the connector labeled "DSKT2" on the system board (see
"System Board Components" on page 68) and route the cable through the clip on the shroud.
1 drive 2 screws (4)
1
2
Vista de pagina 94
1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 161 162

Comentarios a estos manuales

Sin comentarios