Dell PowerEdge C2100 El manual del propietario descargar pdf (Pagina 96)

92 Installing System Components

Figure 3-20. Removing and Installing the Power Supply

Installing the Power Supply

Verify that both power supplies are of the same type and have the

same maximum output power.

Slide the new power supply into the system until the power supply is fully

seated and the release latch snaps into place. See Figure 3-20.

Reconnect your system and peripherals to their electrical outlets, and turn

on the system.

NOTE: When installing, hot-swapping, or hot-adding a new power supply in a

system with two power supplies, allow several seconds for the system to recognize

the power supply and determine its status. The power-supply status indicator turns

green to signify that the power supply is functioning properly. See Figure 1-3.

1 power supply 2 release latch

3 power supply handle

book.book Page 92 Friday, November 8, 2013 11:29 AM

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 143 144

Sin comentarios

Dell PowerEdge C2100 El manual del propietario Pagina 96