Dell 5404 El manual del propietario

Dell Latitude 14 Rugged — 5404Owner's ManualRegulatory Model: P46GRegulatory Type: P46G001

Installing the Optical Drive1. Place the optical drive on to the computer.2. Tighten the screws that secure the optical drive to the computer.3. Insta

4. Perform the following steps as shown in the illustration:a. Unlock back door latch [1].b. Lift the back door upward direction to open it [2].c. Rem

Installing the Bottom Cover1. Tighten the screws that secure I/O, back door, and HDMI to the computer chassis.2. Press firmly on the door until a clic

4. Perform the following steps as shown in the illustration:a. Remove the screws that secure the keyboard door [1].b. Lift the locking tab [2].c. Disc

a. Battery7. Follow the procedures in After Working Inside Your computerRemoving the Memory Module1. Follow the procedures in Before Working Inside Yo

b. Unroute the antenna cables [2].c. Remove the screws that secure the docking board [3].d. Flip the docking board [4].e. Lift the release tab [5].f.

c. Remove the screws that secure the pull tab to the GPU board [3].d. Lift the GPU board from the computer [4].Installing the GPU Board1. Place the GP

Installing the SIM Module1. Slide the SIM module into its place on the computer.2. Close the SIM module bay press latch door.3. Tighten the screws tha

Installing the WLAN Card1. Insert the WLAN card in the slot.2. Connect the screw to secure the cable holder.3. Connect the antenna cables to the WLAN

Installing the WWAN Card1. Insert the WWAN card in the slot.2. Connect the screw to secure the WWAN.3. Connect the cables to the WWAN card.4. Install:

Notes, Cautions, and WarningsNOTE: A NOTE indicates important information that helps you make better use of your computer.CAUTION: A CAUTION indicates

Installing the RF Holder1. Place the RF holder into its place on the computer.2. Tighten the screw that secure the holder to the computer.3. Connect t

Installing the Heatsink1. Align the heatsink to its position on the system board.2. Tighten the screws in the numerical sequence depicted on the brack

a. Bottom Coverb. Optical Drivec. Hard Drived. Battery6. Follow the procedures in After Working Inside Your computerRemoving the RF Holder1. Follow th

b. WWAN Cardc. Bottom Coverd. Optical Drivee. Hard Drivef. Battery6. Follow the procedures in After Working Inside Your computerRemoving the GPS Holde

e. Optical Drivef. Hard Driveg. Battery6. Follow the procedures in After Working Inside Your computerRemoving the Display Assembly1. Follow the proced

5. Remove the screws that secure the display assembly to the computer chassis.6. Flip the computer remove the display assembly.Installing the Display

Removing the I/O Board1. Follow the procedures in Before Working Inside Your Computer2. Remove:a. Batteryb. Hard Drivec. Optical Drived. Bottom Cover3

Installing the I/O Board1. Place the I/O board on the computer.2. Tighten the scews that secure the I/O board to the computer.3. Connect display assem

d. Lift the tab upwards direction [4].e. Lift the locking tab [1].f. Disconnect the optical drive connector cable from the system board [2].4. Remove

Installing the Storage Connector1. Place the storage connector on the computer.2. Tighten the screws that secure the storage connector3. Connect the s

Contents1 Working on Your Computer...5Before Working Inside Your Computer

4. Perform the following steps as shown in the illustration:a. Remove the screws that secure the SSD bracket to the computer [1].b. Lift the SSD brack

c. Optical Drived. Bottom Cover3. Perform the following steps as shown in the illustration:a. Lift the locking tab [1].b. Disconnect the USH board cab

e. Remove the screws that secure the driving board to the computer [5]f. Lift the driving board from the computer [6].Installing the Driving Board1. P

Installing the Battery Connector1. Place the battery connector on the system board..2. Tighten the screws that secure the battery connector to the com

4. Perform the following steps as shown in the illustration:a. Unlock the latch door[1].b. Lift it downwards to open it [2].c. Remove the screws that

Installing the System Board1. Place the system board on the computer.2. Tighten the screws that secure the system board to the computer.3. Connect the

3System SetupSystem Setup enables you to manage your computer hardware and specify BIOS‐level options. From the System Setup, you can:• Change the NVR

Table 1. Navigation KeysKeys NavigationUp arrow Moves to the previous field.Down arrow Moves to the next field.<Enter> Allows you to select a va

Option DescriptionBy default, all the options are checked. You can also deselect any option or change the boot order.Boot List Option Allows you to ch

Option Description• RAID On: This option is enabled by default.Drives Allows you to configure the SATA drives on board. All drives are enabled by defa

Removing the Display Assembly...24Installing the

Option DescriptionRGB Keyboard Backlight This option configures the RGB keyboard backlight feature. There are six available colors: four preset colors

Option DescriptionNOTE: Successful password changes take effect immediately.Default Setting: Not setSystem Password Allows you to set, change or delet

Option DescriptionNOTE: The Activate and Disable options will permanently activate or disable the feature and no further changes will be allowedDeacti

Option DescriptionNOTE: If you disable the Custom Mode, all the changes made will be erased and the keys will restore to default settings.Table 7. Per

Option DescriptionNOTE: This feature is only functional when the AC power adapter is connected. If the AC power adapter is removed during Standby, the

Option DescriptionIntel Smart Connect TechnologyThis option, if enabled, periodically senses the nearby wireless connections, while the system is in s

Option Description• Thorough (default)• AutoExtended BIOS POST Time Allows you to create an additional pre-boot delay. The options are : 0 seconds, 5

Table 12. MaintenanceOption DescriptionService Tag Displays the Service Tag of your computer.Asset Tag Allows you to create a system asset tag if an a

Password Type DescriptionSystem password Password that you must enter to log on to your system.Setup password Password that you must enter to access a

The System Security screen is displayed.2. In the System Security screen, verify that Password Status is Unlocked.3. Select System Password, alter or

1Working on Your Computer Before Working Inside Your ComputerUse the following safety guidelines to help protect your computer from potential damage a

4DiagnosticsIf you experience a problem with your computer, run the ePSA diagnostics before contacting Dell for technical assistance. The purpose of r

Device Status LightsIcon DescriptionTurns on when you turn on the computer and blinks when the computer is in a power management mode.Turns on when th

5SpecificationsNOTE: Offerings may vary by region. For more information regarding the configuration of your computer, click Start (Start icon) → Hel

Feature SpecificationStereo conversion 24-bit (analog-to-digital and digital-to-analog)Interface:Internal HD audioExternal microphone-in/stereo headph

Feature Specification• one 19-pin HDMI connectorNetwork adapter one RJ-45 connector (second optional)USB 2.0 two 4-pin USB 2.0 compliant connectorUSB

Table 22. KeyboardFeature SpecificationNumber of keys 84 keys: US English, Thai, French-Canadian, Korean, Russian, Hebrew, English-InternationalLayout

Input frequency 50 Hz to 60 HzOutput power 65 W/90 WOutput current 3.34 A/4.62 A(continuous)Rated output voltage 19.5 +/– 1.0 VDCTemperature range:Ope

Feature SpecificationOperating -15.24 m to 4572 (-50 ft to 15,000 ft)3048 (–50 ft to 10,000 ft ft)Non-Operating '-15.24 m to 4572 (-50 ft to 15,0

6Contacting DellNOTE: If you do not have an active Internet connection, you can find contact information on your purchase invoice, packing slip, bill,

3. If the computer is connected to a docking device (docked), undock it.CAUTION: To disconnect a network cable, first unplug the cable from your compu

2. Click the arrow in the lower-right corner of the Start menu as shown below, and then click Shut Down .2. Ensure that the computer and all attached

2Removing and Installing ComponentsThis section provides detailed information on how to remove or install the components from your computer.Removing t

Removing the Hard Drive1. Follow the procedures in Before Working Inside Your Computer2. Remove:a. Battery3. Perform the following steps as shown in t