Dell P01S Información técnica descargar pdf (Pagina 18)



Warning: Battery is critically low —

The battery is running out of charge. Connect the computer to an electrical outlet; otherwise, activate hibernate mode or shut down the computer.



System Messages



Alert! Previous attempts at booting this system have failed at checkpoint [nnnn]. For help in resolving this problem, please note this checkpoint and

contact Dell Technical Support —

The computer failed to complete the start routine three consecutive times for the same error (see Contacting Dell for assistance).



CMOS checksum error —

Possible system board failure or RTC battery low. Contact Dell (see Contacting Dell).



CPU fan failure —

Processor fan failure. Contact Dell (see Contacting Dell).



Hard-disk drive failure —

Possible hard drive failure during hard drive POST. Check cables, swap hard disks, or see Contacting Dell for assistance.



Hard-disk drive read failure —

Possible hard drive failure during hard-drive start test (see Contacting Dell for assistance).



Keyboard failure —

Keyboard failure or keyboard cable loose. Contact Dell (see Contacting Dell).



No boot device available —

No bootable partition on hard drive, or the hard drive cable is loose, or no bootable device exists.

l If the hard drive is your boot device, ensure that the drive is partitioned as a boot device.

l Enter system setup and ensure that the boot sequence information is correct.



No timer tick interrupt —

A chip on the system board might be malfunctioning or system board failure (see Contacting Dell for assistance).



USB over current error —

Disconnect the USB device. Use external power source for the USB device.



NOTICE - Hard Drive SELF MONITORING SYSTEM has reported that a parameter has exceeded its normal operating range. Dell recommends that you

back up your data regularly. A parameter out of range may or may not indicate a potential hard drive problem —

S.M.A.R.T error, possible hard drive failure. This feature can be enabled or disabled in BIOS setup.



Troubleshooting Software and Hardware Problems

If a device is either not detected during the operating system setup or is detected but incorrectly configured, you can use the Hardware Troubleshooter to

resolve the incompatibility.

NOTE: If the message you received is not listed in the table, see the documentation for either the operating system or the program that was running

when the message appeared.

1 2 ... 13 14 15 16 17 18 19 20 21 22

Comentarios a estos manuales

Sin comentarios

Dell P01S Información técnica Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Cuadernos Dell P01S