Dell Broadcom NetXtreme Family of Adapters Guía de usuario descargar pdf (Pagina 273)

User Guide NetXtreme II

September 2013

Broadcom Corporation

Document INGSRVT78-CDUM100-R Configuring Teaming Page 273

7. From the Available Adapters list, click the adapter you want to add to the team and then click Add. Remove team

members from the Team Members list by clicking the adapter and then clicking Remove. Click Next.

NOTE: There must be at least one Broadcom network adapter assigned to the team.

The TCP Offload Engine (TOE), Large Send Offload (LSO) and Checksum Offload (CO) columns indicate if the TOE,

LSO, Jumbo MTU, and/or the CO properties are supported for the adapter. The TOE, LSO, Jumbo MTU, and CO

properties are enabled for a team only when all of the members support and are configured for the feature. If this is the

case, then the team offload capabilities appear on the bottom of the screen.

NOTES:

• Adding a network adapter to a team where its driver is disabled may negatively affect the offloading capabilities

of the team. This may have an impact on the team’s performance. Therefore, it is recommended that only driver-

enabled network adapters be added as members to a team.

8. If you want to designate one of the adapters as a standby member (optional), select Use the following member as a

standby member, then choose the standby member from the list of adapters.

9. The Auto-Fallback Disable mode feature allows the team to continue using the standby member rather than switching

back to the primary member if the primary member comes back online. To enable this feature, select Enable Auto-

Fallback Disable mode. Click Next.

1 2 ... 268 269 270 271 272 273 274 275 276 277 278 ... 331 332

Sin comentarios

Dell Broadcom NetXtreme Family of Adapters Guía de usuario Pagina 273