Dell R2 Guía de usuario descargar pdf (Pagina 10)

10 Configuring Your System for the First Time

Configuring TCP/IP Using a Static IP Address

The following procedure is required if a static TCP/IP configuration was previously used. By default,

systems running Windows Storage Server 2003 operating systems attempt to obtain the TCP/IP

configuration from a DHCP server on your network.

NOTE: To perform this procedure, you must be a member of the Administrators group or the Network Configuration

Operators group on the local computer.

Click

Start

→

Settings

→

Control Panel

→

Network Connections

Right-click the network connection that you want to configure, and click

Properties

On the

General

tab (for a local area connection) or the

Networking

tab (for all other connections),

click

Internet Protocol (TCP/IP)

and click

Properties

Click

Use the following IP address

If you are configuring a local area connection, type the appropriate information in the

IP address

Subnet mask

, and

Default gateway

fields.

If you are configuring a connection, type the IP address in the

IP address

field.

Click

Use the following DNS server addresses

In the

Preferred DNS server and Alternate DNS server

field, type the primary and secondary DNS

server addresses.

Configure additional IP addresses, if required. Otherwise, go to step 9.

Click

Advanced

On the

IP Settings

tab under

IP addresses

, click

Add

Under

TCP/IP Address

, type an IP address and subnet mask in the appropriate fields, and click

Add

Repeat step b and step c for each additional IP address.

Configure additional default gateways, if required. Otherwise, go to step 10.

On the

IP Settings

tab under

Default gateways

, click

Add

Under

TCP/IP Gateway Address

in the

Gateway

field, type the IP address of the default gateway.

To manually configure a default route metric, clear the

Automatic

metric

check box and type a

metric in the

Metric

field.

Click

Add

Repeat step b through step d for each default gateway (if required).

Configure a custom metric for this connection, if required. Otherwise, go to step 11.

Clear the

Automatic metric

check box.

In the

Interface metric

field, type the appropriate metric.

Click

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 57 58

Comentarios a estos manuales

Sin comentarios

Dell R2 Guía de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Dell R2