Dell TL24iSCSIxSAS Guía de usuario

Page 1 Dell™ Model TL2000/TL4000 1GB iSCSI to SAS bridge iSCSI initiators Table of Contents Install the iSCSI Initiator Software (iSCSI-attached

Page 10 <Password> is the target CHAP secret. <Authtype> is either 0 for no authentication, 1 for Target CHAP, or 2 for Mutual CHAP.

Page 11 Windows Host Setup If you are using a Windows host network, the following section provides a framework for preparing your network for iSC

Page 12 Linux Host Setup If you are using a Linux host network, the following section provides a framework for preparing your network for iSCSI.

Page 13 Note: every time you restart the iscsi services, all the sessions will be opened back up again. Also, the session ID’s change, so it will

Page 14 6) Re-configure your iSCSI initiator 7) Re-configure you ISV Note: To delete the targets in Linux use the command below: iscsiadm --mod

Page 15 Reference information Terminology CHAP (Challenge Handshake Authentication Protocol). An optional security protocol used to control acce

Page 16 Windows, and Windows Server are either registered trademarks or trademarks of Microsoft Corporation in the United States and other countr

Page 2 Connect to the TL2000/TL4000 from the Host Server ... 9 If you are using Wind

Page 3 Install the iSCSI Initiator Software (iSCSI-attached Host Servers Only) Your Dell™ Model TL24iSCSIxSAS 1Gb iSCSI to SAS™ bridge requires

Page 4 Installing the iSCSI Initiator on a RHEL 5 System You can install the iSCSI initiator software on Red Hat Enterprise Linux 5 systems eithe

Page 5 Installing the iSCSI Initiator on a SLES 10 SP1 System You can install the iSCSI initiator software on SUSE Linux Enterprise Server Versio

Page 6 Using Linux Server Configuration of the iSCSI initiator for Red Hat® Enterprise Linux® version 4 and SUSE® Linux Enterprise Server 9 distr

Page 7 Using Windows Server 2003 or Windows Server 2008 GUI version 1) Click Start−>Programs−>Microsoft iSCSI Initiator or Start −>All

Page 8 Note: If you are configuring Mutual CHAP authentication in Linux, you must also add an IncomingUsername= and IncomingPassword= entry after

Page 9 9) If you are using CHAP authentication, enter the CHAP username and password. To enable 10) Mutual CHAP, select and enter the Mutual CHA