Dell 610D Especificaciones descargar pdf (Pagina 79)

To replace the hard drive in the hard drive bay:



1. Follow the procedures in "Before You Begin."



2. Turn the computer over, and remove the hard drive screws.



3. Slide the hard drive out of the computer.



4. Remove the new drive from its packaging.

Save the original packaging for storing or shipping the hard drive.



5. Slide the hard drive into the bay until it is fully seated.



6. Replace and tighten the screws.



7. Use the Operating System CD to install the operating system for your computer.



8. Use the Drivers and Utilities CD to install the drivers and utilities for your computer.

Keyboard



1. Follow the instructions in "Before You Begin."



2. Turn the computer right-side up and open it.

NOTICE: Hard drives are extremely fragile; even a slight bump can damage the drive.

NOTE: Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.

screws (2)

hard drive

NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting Against Electrostatic Discharge" in the

Product Information Guide.

NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the connector.

CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

as the back panel) on the computer.