Dell E600i Guía de instalación descargar pdf (Pagina 31)

Installing RPMs, Line Cards, and SFMs | 31

NOTE: The blank panels do not have circuit boards or levers. Align the blank with the guides and gently slide

toward the backplane.

Figure 7-1. Installing RPM into the E600i

To install line cards and RPMs:

NOTE: The blank panels do not have circuit boards or levers. Align the blank with the guides and gently slide

toward the backplane.

5 Follow the same installation procedure for the remaining cards and slots, in the appropriate order.

Step Task

1 Remove the line card from its box and carefully remove the line card from the anti-static packaging.

2 Align the RPM with the guide and gently slide it into the slot until you feel the connectors engage with the chassis

backplane.

NOTE: Hold the card by the edges. Avoid touching the printed circuit board and connector pins. Extend the

top and bottom card levers before you insert the card into the slot.

3 Rotate the levers to seat the backplane connectors and line card in place.

4 Secure card and blanks in place by tightening the top and captive screws on each card.

5 Follow the same installation procedure for the remaining cards and slots, in the appropriate order.

Step Task

FN00079

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 75 76

Sin comentarios

Dell E600i Guía de instalación Pagina 31