Dell Force10 S55T Manual de inicio rápido descargar pdf (Pagina 20)

18 Installing the Software

Serial Console

The RS-232 console port is labeled on the chassis. It is in the upper right-hand

side, as you face the rear of the chassis.

Accessing the RJ-45 console port with a DB-9 adapter

You can connect to the console using an RJ-45 to RJ-45 rollover cable and an

RJ-45 to DB-9 female DTE adapter to a terminal server (for example, PC).

Table 2-1 lists the pin assignments.

S55 S60

Step Task

1 Install an RJ-45 copper cable into the console port.Use a rollover (crossover)

cable to connect the S55 or S60 console port to a terminal server.

2 Connect the other end of the cable to the DTE terminal server.

3 Terminal settings on the console port cannot be changed in the software and are

set as follows:

9600 baud rate

No parity

8 data bits

1 stop bit

No flow control

Table 2-1. Pin Assignments Between the Console and a DTE Terminal Server

S55/S60

Console Port

RJ-45 to RJ-45 Rollover Cable RJ-45 to DB-9

Adapter

Terminal

Server Device

Signal RJ-45 pinout RJ-45 Pinout DB-9 Pin Signal

RTS 1 8 8 CTS

RJ-45

Console Port

Console

Port

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Sin comentarios

Dell Force10 S55T Manual de inicio rápido Pagina 20