Dell MD3000i Cómo utilizar descargar pdf (Pagina 14)

14 Introduction

Ethernet Pass-Through Module

The Ethernet pass-through module provides a non-switched connection

between the server modules and an external Ethernet device.

Table 1-2 summarizes the supported Ethernet module configurations.

The following are the supported cable types for Gigabit Ethernet:

• Optical cables with LC connectors

• CAT5e cables with RJ45 connectors

• CAT6 cables with RJ45 connectors

The following are the supported cable types for 10 Gigabit Ethernet:

• Optical cables with LC connectors

• CAT6 cable with RJ45 connectors

• SFP+ Direct Attached cables

NOTE: For information about supported cable types to connect the blade chassis to

an external switch or storage system, see the switch documentation.

Fibre Channel Module

You can configure the PowerEdge blade cluster with two hot-pluggable Fibre

Channel switch modules installed on a PowerEdge 1855/1955 system or up to

four hot-pluggable Fibre Channel switch/pass-through modules installed on

the PowerEdge M1000e system to provide Fibre Channel connection between

the server modules and storage system(s).

Table 1-2. Supported Ethernet Module Configurations

Ethernet Switch Module for iSCSI Ethernet Pass-Through Module for iSCSI

Switch-attached configuration to

four supported Dell/EMC or

PowerVault iSCSI storage systems or

one PS Series group

Direct-attached configuration to a

Dell/EMC or PowerVault iSCSI storage

system

Switch-attached configuration to an

external iSCSI network with up to

four supported Dell/EMC or

PowerVault iSCSI storage systems or

one PS Series group

Switch-attached configuration to an

external iSCSI network with up to four

supported Dell/EMC or PowerVault

iSCSI storage systems or one PS Series

group

book.book Page 14 Monday, April 19, 2010 5:06 PM

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Sin comentarios

Dell MD3000i Cómo utilizar Pagina 14