Dell Microsoft Windows Compute Cluster Server 2003 Service Pack 1 Manual de instalación descargar pdf (Pagina 16)

16 Installation Guide

Adding PowerEdge-Specific Drivers to the RIS Image

To complete the configuration of Compute Cluster Server 2003 on

PowerEdge systems, you must install additional drivers. Download the drivers

applicable to your cluster from the Dell Support website at support.dell.com

depending on the compute node hardware configuration.

The drivers that must

be downloaded are listed below (select Windows Server 2003 x64 as the

operating system).

• Network Driver for Broadcom NetXtreme II Family of Adapters, required.

• SAS Non-RAID Controllers Driver, Dell SAS Integrated, required if the

compute nodes have a SAS adapter.

• SAS RAID devices driver, Dell PERC Integrated, required if the compute

nodes have a PERC adapter.

To integrate the afore-mentioned drivers into the RIS image, follow the instructions

in this section.

NOTE: Throughout this section, D:\ refers to the RIS image partition and C:\ refers

to the system boot directory.

Open Windows Explorer.

Navigate to the image directory on the RIS image partition.

If the defaults were picked during the RIS image creation, the RIS image

directory is

D:\RemoteInstall\Setup\English\Images\WINDOWS

, where

D:\

is the RIS image partition.

Create a directory named

$OEM$

and create two subdirectories in this

directory and name them as

textmode

and

. In the

directory, create a

subdirectory named

drivers

. Under the

drivers

subdirectory, create a

subdirectory named

nic

The directory structure should resemble Figure 1-2:

Figure 1-2. $OEM$ Directory Structure

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Dell Microsoft Windows Compute Cluster Server 2003 Service Pack 1 Manual de instalación Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Dell Microsoft Windows Compute Cluster Server 2003 Service Pack 1