Dell PowerEdge M IO Aggregator El manual del propietario descargar pdf (Pagina 168)

158 | Interfaces

www.dell.com | support.dell.com

Clearing Interface Counters

The counters in the show interfaces command are reset by the clear counters command. This command does

not clear the counters captured by any SNMP program.

To clear the counters, use the following command in EXEC Privilege mode:

When you enter this command, you must confirm that you want FTOS to clear the interface counters for

that interface (Figure 9-24).

Figure 9-24. Clearing an Interface

Command Syntax Command Mode Purpose

clear counters [interface]

EXEC Privilege Clear the counters used in the show interface commands for all

VRRP groups, VLANs, and physical interfaces or selected ones.

Without an interface specified, the command clears all interface

counters.

• (OPTIONAL) Enter the following interface keywords and slot/

port or number information:

• For a Loopback interface, enter the keyword

loopback followed

by a number from 0 to 16383.

• For a Port Channel interface, enter the keyword

port-channel

followed by a number from 1 to 128.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port numbers.

• For a VLAN, enter the keyword

vlan followed by a number

from 1 to 4094.

FTOS#clear counters tengig 0/0

Clear counters on TenGigabitEthernet 0/0 [confirm]

FTOS#

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 299 300

Sin comentarios

Dell PowerEdge M IO Aggregator El manual del propietario Pagina 168