Dell Vizioncore Guía de inicio rápido descargar pdf (Pagina 48)

48 vFoglight

Getting Started Guide

See the file fglam.config.xml in the directory in which the vFoglight Agent

Manager is installed for details about these and other configuration options. See

also “Configuring the vFoglight Agent Manager” in the Installation and Setup

Guide for information about a vFoglight Agent Manager configuration interface

that you can run after installation.

The vFoglight Agent Manager automatically detects HA-enabled Management

Servers and configures itself for them. However, you might need to perform some

additional configuration if, for example, a Management Server in the HA cluster

has special SSL certificate requirements or if it is using a proxy.

Depending on the platform on which the vFoglight Agent Manager is installed

and the mode in which vFoglight is running, you may need to perform additional

configuration steps. For example:

• If you are running vFoglight in HA mode, see “Getting Started with Server

Commands” (in the chapter “Managing the vFoglight Management Server”) in

the Command-Line Reference Guide for information about configuring the

Remote Monitor utility.

Start the vFoglight Agent Manager: See “Running the vFoglight Agent

Manager” in the Installation and Setup Guide for information about starting the

vFoglight Agent Manager.

See “Running the vFoglight Agent Manager” in the Command-Line Reference

Guide for information about starting the vFoglight Agent Manager using the

command-line interface.

Part 5: Deploying and Creating Agents

You must install and configure the vFoglight Agent Manager before deploying agents

that are installed on a monitored host. The steps outlined in this section assume that you

are deploying agents managed by the vFoglight Agent Manager. In addition, they

assume that you have already installed and (if necessary) configured the vFoglight

Agent Manager on each host where you want to deploy agents. If you have not, refer to

Part 4: Installing, Configuring, and Starting the vFoglight Agent Manager before

proceeding.

Note This is only necessary with vFoglight Pro. vFoglight SE does not require additional agents.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 63 64

Sin comentarios

Dell Vizioncore Guía de inicio rápido Pagina 48