Dell PowerConnect W-AirWave 7.4 Manual de usuario descargar pdf (Pagina 44)

44 | Configuring AMP Dell PowerConnect W-AirWave 7.4 | User Guide

3. On the AMP Setup > Network page, locate the Static Routes area. This section displays network, subnet

mask, and gateway settings that you have defined elsewhere from a command-line interface.

4. Select Save when you have completed all changes on the AMP Setup > Network page, or select Revert to

return to the last settings. Save restarts any affected services and may temporarily disrupt your network

connection.

What Next?

 Go to additional tabs in the AMP Setup section to continue additional setup configurations.

 Complete the required configurations in this chapter before proceeding. AirWave support remains available to

you for any phase of AirWave configuration.

Creating AirWave Users

AirWave installs with only one AMP user—the admin, who is authorized to:

 define additional users with varying levels of privilege, be it manage read/write or monitoring.

 limit the viewable devices as well as the level of access a user has to the devices.

Each general user that you add needs a Username, a Password, and a Role. Use unique and meaningful user

names as they are recorded in the log files when you or other users make changes in AirWave.

The user role defines the user type, access level, and the top folder for that user. User roles are defined on the

AMP Setup > Roles page. Refer to the next procedure in this chapter for additional information, “Creating

AirWave User Roles” on page46.

The admin user can provide optional additional information about the user including the user's real name, email

address, phone number, and so forth.

Perform the following steps to display, add, edit, or delete AirWave users of any privilege level. You must be an

admin user to complete these steps.

1. Go to the AMP Setup > Users page. This page displays all users currently configured in AirWave. Figure 18

illustrates the contents and layout of this page.

Figure 18 AMP Setup > Users Page Illustration

Secondary ntp2.yourdomain.com Sets the IP address or DNS name for the secondary NTP server.

Table 20 AMP Setup > Network > Secondary Network Fields and Default Values (Continued)

Setting Default Description

NOTE: This section does not enable you to configure new routes or remove existing routes.

NOTE: Username and password are not required if you configure AirWave to use RADIUS or TACACS authentication. You do not

need to add individual users to the AirWave server if you use RADIUS or TACACS authentication.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 309 310

Sin comentarios

Dell PowerConnect W-AirWave 7.4 Manual de usuario Pagina 44