Dell PowerConnect W-AirWave 7.6 Guía de usuario descargar pdf (Pagina 8)

Figure 6: Adding an additional Instant device to AirWave

The golden template configuration from the first Instant network is used to provision the second Instant network in

the new folder. When provisioning is complete, the status of the device will change from Verifying to Good.

Changing the Mode to Monitor Only for New Instant Devices

A best practice for using Instant in AirWave is to change the mode for new devices to Monitor Only. This ensures

that the configuration for the new devices does not get unintentionally overwritten and is a consistent behavior and

practice throughout AirWave.

1. Navigate to AP/Devices > List page.

2. Filter the devices by the folder name using the Folder drop down menu on the top portion of the page.

3. Select the Modify Devices (wrench) icon, and select all devices.

4. Select the Monitor Only radio button.

5. Click the Management Mode button. This opens the Confirm Changes page. You can apply the changes now or

schedule the change to be applied later.

Figure 7: Changing the mode to Monitor Only

AirWave Pages with Instant-Specific Features

The following is a summary of AirWave pages affected by Dell PowerConnect W-Instant support:

l APs/Devices > New: When a Dell PowerConnect W-Instant device appears in the APs/Devices > New page, an

admin user can mouse over the value on the Type column to display the device's Shared Secret with AirWave.

l APs/Devices > List: The Virtual Controller is listed as an additional device, even though it is part of the existing

set of IAPs. You can identify the IAP acting as the Virtual Controller by their identical LAN MAC addresses.

8 Dell PowerConnect W-Instant in W-AirWave 7.6 | Deployment Guide

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Sin comentarios

Dell PowerConnect W-AirWave 7.6 Guía de usuario Pagina 8