Dell PowerVault 136T Especificaciones descargar pdf (Pagina 19)

Step 2 Slide the Tape Drive Module into position and tighten the two captive thumbscrews.

CAUTION: After installing the Tape Drive Module, power up the library. Wait 2 minutes before connecting the SCSI bus cable to

the drive SCSI connector.

Step 3 If you have other library features to be installed, go to Start Installation to find the correct procedure, otherwise go to Cables from Hosts.



Figure 2. Installing a Tape Drive Module

Installing a Redundant DC Power Supply

Refer to Figure 3.

Tools required: None.

Step 1 From the rear of the Dell PowerVault 136T LTO Library, locate the slot where the redundant DC Power Supply will be installed.

l Loosen the two captive thumbscrews on the cover plate and remove the cover plate.

Step 2 Position the Power Supply with the LED as shown and slide it into position until it mates with the Power Distribution PCBA then tighten the

two captive thumbscrews.

Step 3 If you have other library features to be installed, go to Start Installation to find the correct procedure, otherwise go to Cables from Hosts.



1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 107 108

Sin comentarios

Dell PowerVault 136T Especificaciones Pagina 19