Dell POWER VAULT 130T LIBRARY 130T Guía de instalación Pagina 1

www.dell.com®Dell PowerVault™ 130T LibraryDRIVE INSTALLATION GUIDE

6 Drive Tray Assembly Conversion InstructionsFigure 4. Connecting the SCSI cableConnecting the SCSI cableCAUTION: The tape drive interface cable (P98

Drive Tray Conversion Instructions 79. Close the hinged door at the rear of the library.10. Tighten the two thumbscrews to secure the door.11. Connec

8 Drive Tray Assembly Conversion InstructionsScroll using the arrow buttons to select the correct drive (drives are numbered 0 through 3 starting fro

®Printed in the U.S.A.5085D

www.dell.com®Dell PowerVault™ 130T LibraryDRIVE INSTALLATION GUIDE

____________________Information in this document is subject to change without notice.© 1997–1998 Dell Computer Corporation. All rights reserved.Reprod

Drive Tray Conversion Instructions 1PowerVault 130T DriveInstallation InstructionsDLT Drive Tray AssemblyThese installation instructions describes ho

2 Drive Tray Assembly Conversion InstructionsFigure 1. Back Vziew of Drive Tray AssemblyBack View of Drive Tray AssemblyItem NumberParts Description1

Drive Tray Conversion Instructions 3Figure 2. Interface Connection and PowerInterface Connection and Power2. Disconnect the power cable from the tape

4 Drive Tray Assembly Conversion Instructions5. Loosen the two thumbscrews at the rear of the drive assembly.6. Using both hands, remove the drive as

Drive Tray Conversion Instructions 5Setting TermPwr2. To check terminator power (TERMPWR), remove the two power supply cover screws using a Torx driv