Dell Force10 S60-44T Manual de instalación Pagina 20

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 45
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 19
Install the S60 System | 20
The PWR Light Emitting Diode (LED) blinks until the boot-up sequence is complete. When the boot up
is complete, the PWD LED is steadily lit.
The Stack ID LED displays a digit to show the position of the unit in a stacking chain. For a single
chassis, a 0 displays.
AC Power
Connect the plug to each AC receptacle (
Figure 3-7
). Ensure the power cord is secure.
As soon as the cable is connected between the S60 system and the power source, the system is
powered-up; there is no on/off switch.
Figure 3-7. AC Power Connection
DC Power
To connect DC power (
Figure 3-8
), follow these steps:
Figure 3-8. DC power connection
Step Task
1 Remove the small plastic cover from the DC connectors.
2 Attach the connectors to both the DC PSUs at the rear of the S60 system. Ensure the connection is secure.
3 Replace the plastic cover over the DC connectors.
4 Turn the power switch on.
Vista de pagina 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 44 45

Comentarios a estos manuales

Sin comentarios