
90 Installing System Components
5
Holding the card by its edges, position the card so that the card-edge
connector aligns with the expansion-card connector on the expansion-card
riser.
6
Insert the card-edge connector firmly into the expansion-card connector
until the card is fully seated.
7
Close the expansion-card latch. See Figure 3-8.
Figure 3-8. Removing and Installing an Expansion Card
8
Connect any cables to the expansion card.
9
Close the system. See "Closing the System" on page 81.
10
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
1 expansion-card latch 2 expansion card
3 expansion-card riser
book.book Page 90 Wednesday, December 22, 2010 2:13 PM
Comentarios a estos manuales