Dell PowerEdge 1655MC Manual de usuario descargar pdf (Pagina 12)

Back to Contents Page

Using the System Setup Program

Dell™PowerEdge™1655MCSystemsUser'sGuide

Entering the System Setup Program

System Setup Options

Using the System Password Feature

Using the Setup Password Feature

Asset Tag Utility

Each server module has its own System Setup program. Throughout this section, the server modules are referred to as systems since each server module

functions independently as a system.

Each time you turn on your system, the system compares the configuration of the hardware installed in the system to the hardware listed in the system

configuration information stored in NVRAM on the system board. If the system detects a discrepancy, it generates error messages that identify the incorrect

configuration settings. The system then prompts you to enter the System Setup program to correct the settings.

You can use the System Setup program as follows:

l To change the system configuration information after you add, change, or remove any hardware in your system

l To set or change user-selectable options—forexample,thetimeordateonyoursystem

l To enable or disable any integrated device in your system

After you set up your system, run the System Setup program to familiarize yourself with your system configuration information and optional settings.

Entering the System Setup Program

1. Turn on your system.

If your system is already on, shut it down, and then turn it on again.

2. Press <F2> immediately after you see the following message in the upper-right corner of the screen:

<F2> = System Setup

You can also press <F10> to enter Utility mode or <F12> for PXE Boot. PXE Boot forces a system boot from the network.

If you wait too long and your operating system begins to load into memory, let the system complete the load operation, and then shut down the system

and try again.

You can also enter the System Setup program by responding to certain error messages. See "Responding to Error Messages."

Responding to Error Messages

If an error message appears on your monitor screen while the system is starting up, make a note of the message. Before entering the System Setup program,

see "System Beep Codes" and "System Messages" in your Installation and Troubleshooting Guide for an explanation of the message and suggestions for

correcting any errors.

If you are given an option of pressing either <F1> to continue or <F2> to run the System Setup program, press <F2>.

Using the System Setup Program

Table3-1 lists the keys that you use to view or change information on the System Setup screens and to exit the program.

Table 3-1.SystemSetupNavigationKeys

NOTE: To ensure an orderly system shutdown, consult the documentation that accompanied your operating system.

NOTE: For help using the System Setup program, press <F1> while in the program.

NOTE: After installing a memory upgrade, it is normal for your system to send a message the first time you start your system. In that situation, do not

refer to "System Beep Codes" and "System Messages." Instead, see "Adding Memory" in your Installation and Troubleshooting Guide for instructions.

Keys

Action

Down arrow or <Tab>

Moves to the next field.

Up arrow or <Shift><Tab>

Moves to the previous field.

Left and right arrows or Spacebar

Cycles through the settings in a field. In many fields, you can also type the appropriate value.

<Esc>

Exits the System Setup program and restarts the system if any changes were made.