Dell PowerEdge Rack Enclosure 4220 Manual de usuario descargar pdf (Pagina 33)

Installation Guide 31

Removing and Installing the Back Door Stabilizer Bars

The top and bottom bars used to stabilize the back doors can be removed,

making it easier to route cables through the top and bottom of the rack.

Open the back doors.

Pull and hold the plungers on each side of the bar, and pull the bar up

and away from the rack (see Figure 1-18).

After routing your cables, replace the bars by aligning the tabs on the bars

with the corresponding holes in the rack and pushing in and down until

the plungers lock into place.

Figure 1-18. Removing and Installing the Back Door Stabilizer Bars

1 back door stabilizer bar (top) 2 plunger (2 per bar)

3 back door stabilizer bar (bottom)

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 185 186

Sin comentarios

Dell PowerEdge Rack Enclosure 4220 Manual de usuario Pagina 33