Dell PowerEdge RAID Controller 5i Manual de usuario descargar pdf (Pagina 39)

Hardware Installation and Configuration 37

Figure 3-11. Removing the PERC 5/i Adapter

NOTE: See the Hardware Owner's Manual for information on removing the PERC 5/i from the system.

Removing the DIMM from a PERC 5/i Card

This section describes how to remove the memory module on a PERC 5/i Adapter or PERC 5/i that is

currently installed in a system.

NOTE: PERC 5 cards support DELL-qualified 256-MB DDRII 400MHz ECC-registered DIMMs with x16 DRAM

components. Installing unsupported memory causes the system to hang at POST.

Perform a controlled shutdown on the system in which the PERC 5/i is installed and remove the

PERC 5/i from the system by following the instructions detailed in the section "Removing the

PERC 5/i Adapter" on page 35.

CAUTION: Running a system without the system cover installed can cause damage due to improper cooling.

Remove the DIMM by pressing down on the tabs at each edge of the DIMM connector and lifting the

DIMM off the controller.

NOTE: The location of the PERC 5/i varies from system to system. See the Hardware Owner’s Manual

that shipped with the system for specific information on the location of the PERC 5/i.

PERC 5/i Adapter

memory module

bracket screw

Dell_PERC5_UG.book Page 37 Tuesday, February 13, 2007 6:02 PM

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 111 112

Sin comentarios

Dell PowerEdge RAID Controller 5i Manual de usuario Pagina 39