Dell PowerVault 210S (SCSI) Manual de usuario descargar pdf (Pagina 20)

1-6 Dell PowerVault 200S and 210S Storage Systems Rack Installation Guide

! 

Repeat steps 1 and 2 to remove the back door from the rack.

Store the doors in an area where they will not fall over while you install the kit.

+!

$%&"

1)

#

1

To install the rail assemblies in the rack, perform the following steps:

1. Ensure that there is enough room in the rack to install the storage system.

The storage system takes 5.25 inches (3Us) of vertical space.

2. If the two adjustable rail-mounting flanges are not already attached to the support

rails, attach one flange to each of the support rails using two 10-32 x 1/2-inch

pan-head screws, as shown in Figure 1-6. Do not tighten the screws at this time.

hinge

release

lever

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Sin comentarios

Dell PowerVault 210S (SCSI) Manual de usuario Pagina 20