Dell PowerVault MD3000 Manual de usuario descargar pdf (Pagina 58)

58 Installing Enclosure Components

CAUTION: Always wear a wrist grounding strap when handling equipment with static-sensitive components.

Perform the following steps to install the new

physical disk

into the carrier:

NOTE: Data from virtual disks created on a PERC 5 SAS controller cannot be migrated to an MD3000 or to an

MD1000 expansion enclosure connected to an MD3000.

If you are replacing a

physical disk

in the carrier, remove the four screws that secure the disk to its

carrier and remove the disk (see Figure 4-3).

Position the replacement

physical disk

into the disk carrier with the disk’s controller board facing

the rear of the carrier.

From the rear of the carrier, slide the

physical disk

into the carrier until it contacts the stop tab at

the front of the carrier.

Secure the

physical disk

to the carrier using the four screws removed earlier. To avoid damaging

the carrier, do not overtighten.

Figure 4-3. Installing a SAS Physical Disk in the Carrier

1 screws (4) 2 physical disk carrier 3 physical disk

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 111 112

Sin comentarios

Dell PowerVault MD3000 Manual de usuario Pagina 58