Dell PowerVault MD3000 Manual de usuario descargar pdf (Pagina 65)

Installing Enclosure Components 65

Figure 4-7. Removing and Replacing the Control Panel

Using a Torx T10 driver, remove all 16 screws from the front faceplate of the enclosure as shown in

Figure 4-7.

Remove the front faceplate from the enclosure and place it on a flat, secure surface.

Slide the control panel assembly straight out from its connector on the backplane (see Figure 4-7).

Installing the Control Panel

Align the top and bottom tabs on the control panel with the insert slots on the edge of the chassis (see

Figure 4-7).

Slide the control panel fully into the slot, making sure that its connector engages into the matching

backplane connector (see Figure 4-7). Also, make sure the guide tab on the control panel is fully

inserted into the mounting slot on the backplane.

Replace the front faceplate and re-attach the 16 screws that hold it in place.

Re-install any

physical disk

s you removed (see "Removing and Installing Physical Disks" on page 56).

Push the enclosure all the way back into the rack and tighten the thumbscrews.

1 faceplate screws (16) 2 control panel 3 thumbscrews

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 111 112

Sin comentarios

Dell PowerVault MD3000 Manual de usuario Pagina 65