Dell PowerVault NX3300 Manual de usuario descargar pdf (Pagina 46)

Figure 14. Removing and Installing a 2.5 Inch Hard-Drive Blank

1. hard-drive blank

2. release button

Installing A 2.5 Inch Hard-Drive Blank

1. If installed, remove the front bezel.

2. Insert the hard-drive blank into the hard-drive slot until the release button clicks into place.

3. If applicable, install the front bezel.

Removing A Hot-Swap Hard Drive

CAUTION: To prevent data loss, ensure that your operating system supports hot-swap drive installation. See the

documentation supplied with your operating system.

1. From the management software, prepare the hard drive for removal. Wait until the indicators on the hard-drive

carrier signal that the hard drive can be removed safely. For more information, see the documentation for the

storage controller.

If the hard drive is online, the green activity/fault indicator flashes as the drive is turned off. When the hard-drive

indicators are off, the hard drive is ready for removal.

2. Press the release button to open the hard-drive carrier release handle.

3. Slide the hard-drive carrier out until it is free of the hard-drive slot.

CAUTION: To maintain proper system cooling, all empty hard-drive slots must have hard-drive blanks installed.

4. Insert a hard-drive blank in the empty hard-drive slot.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 122 123

Sin comentarios

Dell PowerVault NX3300 Manual de usuario Pagina 46