Dell Alienware Aurora R3 (Early 2011) Manual de usuario descargar pdf (Pagina 13)



4. Remove the drive-bay shroud (see Removing the Drive-Bay Shroud).



5. Remove full-length PCI-Express card(s), if any (see Removing the PCI-Express Card(s)).



6. Disconnect the PCI-fan assembly cable from the connector on the master I/O board.



7. Press the tabs and lift the PCI-fan assembly out of the metal brackets on the chassis.

Replacing the PCI-Fan Assembly



1. Follow the instructions in Before You Begin.



2. Align the PCI-fan assembly with the metal brackets on the chassis.



3. Slide the PCI-fan assembly into the chassis.



4. Connect the PCI-fanassemblycabletotheconnectoronthemasterI/Oboard.



5. Replace full-length PCI-Express card(s), if any (see Replacing the PCI-Express Card(s)).



6. Replace the drive-bay shroud (see Replacing the Drive-Bay Shroud).



7. Close the PCI shroud (see Closing the PCI Shroud).



8. Replace the left side-panel (see Replacing the Left Side-Panel).



9. Connect your computer and all attached devices to electrical outlets, and turn them on.

Back to Contents Page



tabs (2)

PCI-fan assembly

PCI-fan assembly cable

CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may

result in damage to the computer.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 63 64

Sin comentarios

Dell Alienware Aurora R3 (Early 2011) Manual de usuario Pagina 13