Dell OptiPlex GX1p Manual de usuario descargar pdf (Pagina 103)

Removing and Replacing Parts on the Midsize Chassis 5-11

,QFK'ULYH$VVHPEO\

To remove a 5.25-inch drive assembly from the middle or lower drive bay, fol-

low these steps:

1. Disconnect the DC power cable and the interface cable from the back of

the drive.

2. Press in on the two retaining tabs (one on each side of the drive), and slide

the drive assembly forward to remove it.

3. Remove the four screws attaching the 5.25-inch drive to the mounting

plate, and lift the drive out of the mounting plate (see Figure 5-10).

When you replace the 5.25-inch drive, align the front of the drive flush with the

tab at the front of the mounting plate. Insert the four screws, and tighten them

in the order stamped on the bottom of the 5.25-inch drive-mounting plate.

retaining tabs (2)

Align the front of the drive

flush with the tab at the

front of the 5.25-inch

drive-mounting plate.

drive-mounting screws (4)

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 169 170

Sin comentarios

Dell OptiPlex GX1p Manual de usuario Pagina 103