Dell XPS 730 H2C (Late 2008) Manual de usuario descargar pdf (Pagina 28)

Back to Contents Page

 Replacing Fans

Dell™XPS™730/730XServiceManual



Removing the Card Slot and Processor Fan Shrouds



1. Follow the procedures in Before You Begin.



2. Remove the computer cover (see Replacing the Computer Cover).



3. Remove the captive screws on top of the shroud you are removing and lift the shroud out of the chassis.



Replacing the Card Slot Fan Assembly



1. Remove the card slot fan shroud (see Removing the Card Slot and Processor Fan Shrouds).



2. Remove any full-length expansion cards (see Replacing the PCI and PCI Express Cards).



3. Disconnect the fan cable from the FAN_CAGE connector on the system board.



4. Remove the front and back screws on the base of the fan cage.



5. Pull the fan cage to towards the rear of the chassis to disengage the cage tabs.



6. Lift the cage off the chassis.



7. To install the card slot fan assembly, connect the fan cable to the FAN_CAGE connector on the system board (see Master Control Board).



8. Align the fan cage tabs with the slots in the chassis. Insert the tabs and push the cage towards the front of the chassis.



9. Screw in the fan retention screws on the front and back of the fan cage.



WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

WARNING: To guard against likelihood of electric shock, laceration by moving fan blades or other unexpected injuries, always unplug your

computer from the electrical outlet before removing the cover.

cage housing

fan cage

screws (2)



1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

Sin comentarios

Dell XPS 730 H2C (Late 2008) Manual de usuario Pagina 28