Dell XPS 730 H2C (Late 2008) Manual de usuario descargar pdf (Pagina 36)

Back to Contents Page

 Replacing the Processor

Dell™XPS™730/730XServiceManual

Removing the Processor

Installing the Processor



1. Follow the procedures in Before You Begin.



2. Remove the computer cover (see Replacing the Computer Cover).



3. Disconnect the power cables from the ATX_POWER and ATX_CPU connectors (see System Board Components) on the system board.



4. Remove the processor fan and heat sink assembly from the computer (see Replacing the Processor Fan Assembly).



5. Press and push the release lever down and out to release it from the tab that secures it.



6. Open the processor cover, if applicable.

Removing the Processor



7. Lift the processor to remove it from the socket, place it aside in a safe and secure place.

Leave the release lever extended in the release position so that the socket is ready for the new processor.



8. Unpackthenewprocessor,beingcarefulnottotouchtheundersideoftheprocessor.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION: Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these steps

incorrectly could damage your system board. For technical service, see the Setup Guide.

WARNING: Despite having a plastic shield, the heat sink assembly may be very hot during normal operation. Be sure that it has had sufficient

time to cool before you touch it.

NOTE: Unless a new heat sink is required for the new processor, reuse the original heat sink assembly when you replace the processor.

processor cover

processor

socket

release lever

CAUTION: When removing or replacing the processor, do not touch any of the pins inside the socket or allow any object to fall on the pins in the

socket.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 51 52

Sin comentarios

Dell XPS 730 H2C (Late 2008) Manual de usuario Pagina 36