
Management: Installing Array Components 237
Control Panel
Removing the Control Panel
1
Turn off the array and host server.
2
Disconnect all the power cables connected to the array.
3
Remove the hard drives from:
– slots 0 to 2 in
PowerVault MD3600i
– slots 0 to 5 in
PowerVault MD3620i
See "Removing a Hard Drive" on page 222.
NOTE: Mark each hard drive with it’s slot position as you remove it.
4
Slide the control panel out of the chassis after:
– Pushing the release tab toward the front of the array in
PowerVault
MD3600i
. See Figure 16-13.
– Pulling the release pin toward the front of the array in
PowerVault
MD3620i
. See Figure 16-14.
Figure 16-13. Removing and Installing the Control Panel-PowerVault MD3600i
1 control panel 2 release tab
book.book Page 237 Tuesday, September 27, 2011 3:13 PM
Comentarios a estos manuales