Dell Personal Computer Dimension 2100 Manual de usuario descargar pdf (Pagina 34)

IDE Configuration Submenu

Table 5. IDE Configuration Submenu Options

Primary IDE Master Submenu

Base I/O Address

If port is set to Enabled, available I/O addresses are 3F8, 3E8, 2F8, and 2E8.

Interrupt

If port is set to Enabled, available interrupts are IRQ3 and IRQ4.

Parallel port

Configures the parallel port. Set this option to Auto (default), Enabled, or Disabled. Depending on the port setting, you can

set the following additional options:

Mode

If port is set to Auto or Enabled, available modes are Output Only, Bi-directional, ECP

(default), and EPP.

NOTE: Before changing this setting, refer to the device manufacturer's documentation for information on

which mode to use.

Base I/O

Address

If port is set to Enabled, available I/O addresses are 378 (default), 278, and 228.

Interrupt

If port is set to Enabled, available interrupts are 7 and 5.

Legacy USB

Support

Set to Disabled if legacy USB support is not desired. Auto (default) and Enabled allow support for legacy USB.

IRQ5

Reserved (default) indicates that the IRQ is reserved for use by legacy devices. Available indicates that a specific IRQ is

available on the computer.

Option

Function

IDE

Controller

Configures the integrated primary and secondary IDE controllers and detects the types of drives attached to them. If set to

Primary, Secondary, or Both, the designated controller(s) are enabled, and the types of drives attached are displayed. If set to

either Primary or Secondary, the other controller is not enabled and the IRQ it normally uses becomes available. If set to

Disabled, the computer cannot detect any drives attached to the controllers and displays None for all four IDE drive options.

Primary IDE

Master

Identifies the first drive attached to the primary IDE interface, usually the boot hard drive. See "Primary IDE Master Submenu."

Primary IDE

Slave

Identifies the second drive attached to the primary IDE interface, usually a second hard drive. The format of this submenu is the

same as the one described in "Primary IDE Master Submenu"

Secondary

IDE Master

Identifies the first drive attached to the secondary IDE interface, if there is one. The format of this submenu is the same as the

one described in "Primary IDE Master Submenu."

Secondary

IDE Slave

Identifies the second drive attached to the secondary IDE interface, usually a CD or tape drive. The format of this submenu is the

same as the one described in "Primary IDE Master Submenu"

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Comentarios a estos manuales

Sin comentarios

Dell Personal Computer Dimension 2100 Manual de usuario Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Cuadernos Dell Personal Computer Dimension 2100