Dell Dimension 4600C Especificaciones descargar pdf (Pagina 14)

Back to Contents Page



Adding Memory



You can increase your computer memory by installing memory modules on the system board. For information on the type of memory supported by your

computer, see "Memory" in "Technical Specifications."



DDR Memory Overview



DDR memory modules should be installed in pairs of matched memory size. This means that if you purchased your computer with 256 MB of memory installed

and you want to upgrade to 512 MB of memory, you should replace the present memory with two 256-MB modules. If the DDR memory modules are not

installed in matched pairs, the computer will continue to operate, but with a slight reduction in performance.



The recommended memory configurations are:

l Install a pair of matched memory modules in connectors DDR_A0 and DDR_B0.

l Do not install ECC memory modules.

l Be sure to install a single memory module in connector DDR_A0 or the connector closest to the processor before you install modules in the other

connectors.



Installing Memory



1. Shut down the computer through the Start menu.

2. Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut

down your computer, turn them off now.



3. Disconnect any telephone or telecommunication lines from the computer.

4. Disconnect your computer and all attached devices from their electrical outlets, and then press the power button to ground the system board.

5. Remove the computer stand, if it is attached.



6. Open the computer cover.

7. Press out the securing clip at each end of the memory module connector.



NOTE: DDR 333 memory operates at 320 MHz when used with an 800-MHz front-side bus microprocessor.

NOTE: Always install DDR memory modules in the order indicated on the system board.

NOTICE: If you remove your original memory modules from the computer during a memory upgrade, keep them separate from any new modules that

you may have, even if you purchased the new modules from Dell. You should install your original memory modules in pairs in connectors DDR_A0 and

DDR_B0. If possible, do not pair an original memory module with a new memory module. Otherwise, your computer may not function at optimal

performance.

NOTE: Memory purchased from Dell is covered under your computer warranty.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Owner's Manual or Product Information

Guide.

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

Comentarios a estos manuales

Sin comentarios

Dell Dimension 4600C Especificaciones Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Dell Dimension 4600C