Dell OpenManage Integration for VMware vCenter 2.1 Manual de usuario descargar pdf (Pagina 158)

Updating the Virtual Appliance Software Version

To prevent data loss, perform an appliance backup prior to beginning the software update.

1. Launch a web Browser then enter https://<ApplianceIPAddress>.

2. In the left pane, click APPLIANCE MAINTENANCE.

3. To update the virtual appliance to the software version listed under Appliance Update, click Update Virtual

Appliance.

4. In the Update Appliance dialog box, the current and available versions are listed. To begin the update, click Update.

5. The system is locked down and put into maintenance mode. When the update is complete, the Appliance page

displays showing the newly installed version. You cannot upgrade to version 2.1 using this option.

Setting Up The HTTP Proxy

You can set up the HTTP proxy settings using the Administration Console or the Dell Management Console.

1. In OpenManage Integration for VMware vCenter, on the Summary tab, use the link to open the Administration

Console.

2. In the Login dialog box, type your password.

3. In the left pane, click APPLIANCE MANAGEMENT.

4. In the Appliance Management page, scroll down to the HTTP Proxy Settings, and then click Edit.

5. In the Edit page, do the following:

a. To enable the use of HTTP Proxy Settings, next to Use HTTP Proxy Settings, select Enable.

b. In the Proxy Server Address text box, enter the proxy server address.

c. In the Proxy Server Port text box, enter the proxy server port.

d. To use proxy credentials, next to Use Proxy Credentials, select Yes.

e. If you are using credentials, in the User Name text box, enter the user name.

f. In the Password text box, type the password.

6. Click Apply.

Setting Up the NTP Servers

Use the Network Time Protocol (NTP) to synchronize the virtual appliance clocks to that of a NTP server.

1. In OpenManage Integration for VMware vCenter, on the Summary tab, use the link to open the Administration

Console.

2. In the Login dialog box, type your password.

3. In the left pane, click APPLIANCE MANAGEMENT.

4. Click Edit for NTP.

5. Select the Enabled check box. Enter the host name or IP address for a Preferred and Secondary NTP Server and

click Apply.

6. To exit, click Cancel.

158

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 193 194

Sin comentarios

Dell OpenManage Integration for VMware vCenter 2.1 Manual de usuario Pagina 158