Dell PowerConnect W-IAP3WN/P Manual de usuario descargar pdf (Pagina 118)

1. Click the Wired link under More at the top right corner of the Instant main window. The Wired window is

displayed.

2. In the Wired window, select the wired profile to modify.

3. Click Edit. The Edit Wired Network window is displayed.

4. Modify the required settings.

5. Click Finish to save the modifications.

Deleting a Wired Profile

To delete a wired profile:

1. Click the Wired link under More at the top right corner of the Instant main window. The Wired window is

displayed.

2. In the Wired window, select the wired profile to delete.

3. Click Delete. The wired profile is deleted.

Link Aggregation Control Protocol for W-IAP220 Series

W-IAP220 Series supports the IEEE 802.11ac standard for high-performance WLAN. To support maximum traffic,

port aggregation is required as it increases throughput and enhances reliability. To support port aggregation, Instant

supports Link Aggregation Control Protocol (LACP) based on the IEEE 802.3ad standard. 802.3ad standard for

Ethernet aggregation uses LACP as a method to manage link configuration and balance traffic among aggregated

ports.

LACP provides a standardized means for exchanging information with partner systems to form a dynamic link

aggregation group. The LACP feature is automatically enabled during W-IAP boots and it dynamically detects the AP

if connected to a partner system with LACP capability, by checking if there is any LACP Protocol Data Unit (PDU)

received on either eth0 or eth1 port.

If the switch in the cluster has the LACP capability, you can combine eth0 and eth1 interfaces into the link

aggregation group to form a single logical interface (port-channel). Port-channels can be used to provide additional

bandwidth or link redundancy between two devices. W-IAP220 Series supports link aggregation using either

standard port-channel (configuration based) or Link Aggregation Control Protocol (protocol signaling based). W-

IAP220 Series can optionally be deployed with LACP configuration to benefit from the higher (greater than 1 Gbps)

aggregate throughput capabilities of the two radios.

The LACP feature is supported only on W-IAP220 Series.

There is no configuration required on the APfor enabling LACP support. However, you can view the status of LACP

on W-IAPs by using the following command:

(Instant AP)# show lacp status

AP LACP Status

--------------

Link Status LACP Rate Num Ports Actor Key Partner Key Partner MAC

----------- --------- --------- --------- ----------- -----------

Up slow 2 17 1 70:81:05:11:3e:80

Slave Interface Status

----------------------

Slave I/f Name Permanent MAC Addr Link Status Member of LAG Link Fail Count

-------------- ------------------ ----------- ------------- ---------------

eth0 6c:f3:7f:c6:76:6e Up Yes 0

eth1 6c:f3:7f:c6:76:6f Up Yes 0

Traffic Sent on Enet Ports

Dell Networking W-Series Instant 6.4.0.2-4.1 | User Guide Wired Profiles | 118

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 376 377

Comentarios a estos manuales

Sin comentarios

Dell PowerConnect W-IAP3WN/P Manual de usuario Pagina 118

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Dell PowerConnect W-IAP3WN/P