Dell PowerConnect W-IAP3WN/P Manual de usuario descargar pdf (Pagina 315)

In the Instant UI

To convert aW-IAP to a hybrid W-IAP:

1. Click the RF link at the top right corner of the Instant UI.

2. Click Show advanced options to view the Radio tab.

3. To enable a spectrum monitor on the 802.11g radio band, in the 2.4 GHz radio profile, select Enabled from the

Background Spectrum Monitoring drop-down list.

4. To enable a spectrum monitor on the 802.11a radio band, in the 5 GHz radio profile, select Enabled from the

Background Spectrum Monitoring drop-down list.

5. Click OK.

In the CLI

To configure 2.4 GHz radio settings:

(Instant AP)(config)# rf dot11g-radio-profile

(Instant AP)(RF dot11 g Radio Profile)# spectrum-monitor

To configure 5 GHz radio settings:

(Instant AP)(config)# rf dot11a-radio-profile

(Instant AP)(RF dot11a Radio Profile)# spectrum-monitor

Converting aW-IAP to a Spectrum Monitor

In spectrum mode, spectrum monitoring is performed on entire bands. However, for the 5 GHz radio, spectrum

monitoring is performed on only one of the three bands:

l 5 GHz - lower

l 5 GHz - middle

l 5 GHz - higher

By default, spectrum monitoring is performed on a higher band of the 5 GHz radio.

You can configure aW-IAP to function as a standalone spectrum monitor using the Instant UI or CLI.

In the Instant UI

To convert aW-IAP to a spectrum monitor:

1. In the Access Points tab, click the AP that you want to convert to a spectrum monitor. The edit link is displayed.

2. Click the edit link. The Edit Access Point window is displayed.

3. Click the Radio tab.

4. From the Access Mode drop-down list, select Spectrum Monitor.

5. Click OK.

6. Reboot the W-IAP for the changes to affect.

7. To enable spectrum monitoring for any other band for the 5 GHz radio:

a. Click the RF link at the upper right corner of the Instant UI.

b. Click Show advanced options to view the Radio tab.

c. For the 5 GHz radio, specify the spectrum band you want that radio to monitor by selecting Lower, Middle, or

Higher from the Standalone spectrum band drop-down list.

d. Click OK.

In the CLI

To convert aW-IAP to a spectrum monitor:

Dell Networking W-Series Instant 6.4.0.2-4.1 | User Guide Spectrum Monitor | 315

1 2 ... 310 311 312 313 314 315 316 317 318 319 320 ... 376 377

Sin comentarios

Dell PowerConnect W-IAP3WN/P Manual de usuario Pagina 315