Dell OpenManage Server Administrator Version 7.0 Manual de usuario descargar pdf (Pagina 124)

124 Controllers

Select a controller object.

Select the

Information/Configuration

subtab.

Select

Set Reconstruct Rate

from the

Available Tasks

drop-down menu.

Click

Execute

You can also locate this task from the Change Controller Properties drop

down menu. For more information, see Change Controller Properties.

Related Information:

• Virtual Disk Task: Reconfigure (Step 1 of 3)

Redundant Path Configuration

Does my Controller Support This Feature? See Supported Features.

Redundant path is supported only on external PERC cards that use firmware

version 6.1 and later. A redundant path internal to the system is not

supported. Dell PowerVault MD1xxx enclosures are supported.

For redundant paths, the enclosure must be in the Unified mode but specific

port connections are not required. A connection from either controller ports

to either EMM In ports creates the redundant path as long as two cables are

used. But, Redundant Path continues to appear in the field even as the

redundant path is removed. The redundant path ceases to appear only when

it is cleared in the storage management.

In a daisy-chain scenario, more than one enclosure can be connected to a

controller in a redundant path mode. You can connect up to three PowerVault

MD1000 and MD1120 to a PERC 6/E controller in a daisy-chained enclosure.

And, you can connect up to four PowerVault MD1200 and MD1220 to a

PERC H800 and PERC H810 controller in a daisy-chained enclosure. For an

example of a daisy chain configuration (for PERC 6/E controller.), see

Figure 7-1.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 373 374

Sin comentarios

Dell OpenManage Server Administrator Version 7.0 Manual de usuario Pagina 124