Dell 4.x Guía de usuario descargar pdf (Pagina 29)

ESXi Deployment Guide 29

Optionally, connect your iSCSI-based network connection to the third

onboard network adapter (if applicable).

For systems with only two onboard network adapters and not

purchased with a network adapter, it is recommended that you add

a supported network adapter.

Turn on your system and follow the steps below:

To enter the system setup, press <F2> when you turn on the system.

For more information, see the documentation that shipped with

your system.

Enable the Virtualization Technology (VT) feature, if available, in the

PowerEdge system.

NOTE: The VT feature is required for Intel processor based servers to

run 64-bit VMs.

Set the universal serial bus (USB) controller to

USB on with BIOS

Support

, if available, in the PowerEdge system.

This setting enables support for USB devices both during and after the

ESXi boot process.

Set the ESXi keyboard language.

Set the ESXi password.

For more information, see "Configuring the Password" on page 32.

Set a static IP address, subnet mask, gateway, and VLAN for the

management connection(s) in the Direct Console User Interface

(DCUI).

Set host name and Domain Name System (DNS) settings.

Set DNS suffix(s).

Install vSphere Client to manage your system.

Replace the Single Server Edition license key with the license key that

you have purchased.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 43 44

Sin comentarios

Dell 4.x Guía de usuario Pagina 29