Dell PowerEdge M IO Aggregator El manual del propietario descargar pdf (Pagina 193)

Port Monitoring | 191

Port Monitoring

Overview

The port monitoring feature allows you to monitor network traffic by forwarding a copy of each

incoming or outgoing packet from one port to another port.

Monitoring Commands

• description

• monitor session

• show config

• show monitor session

• show running-config monitor session

• source (port monitoring)

Important Points to Remember

• Port monitoring is supported on physical ports only; virtual local area networks (VLANs) and

port-channel interfaces do not support port monitoring.

• The monitoring (destination, “MG”) and monitored (source, “MD”) ports must be on the same

switch.

• The monitored (source) interface must be a server-facing interface in the format slot/port, where

valid slot numbers are 0-1 and server-facing port numbers are from 1 to 32. The monitoring

interface must be an uplink port in the chassis.

• FTOS permits a limited set of commands for monitoring ports. To display these commands, use

the ? command.

• A monitoring port may not be a member of a VLAN.

• There may only be one destination port in a monitoring session.

• A source port (MD) can only be monitored by one destination port (MG). If you try to assign a

monitored port to more than one monitoring port, the following error is displayed (Message 1).

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 257 258

Sin comentarios

Dell PowerEdge M IO Aggregator El manual del propietario Pagina 193