4
Configuring VDS CLI
During AFM VDS CLI setup, a CLI-based wizard assists you in configuring the VMware vCenter after OVF deployment.
The virtualization setup wizard launches each time the administrator logs in until you provide the required configuration
information. To change configuration information, you can launch this wizard at any time using the wizard command in
CONFIGURATION mode. To create an administrative account, you must provide your vCenter credentials.
Using the Dynamic Host Configuration Protocol (DHCP)
To configure the AFM plug-in for VMware vCenter VDS command line interface (CLI) using DHCP:
1. Start the VDS CLI session using SSH.
2. Log in using your username and password.
– The default username is vadmin and the default password is vadmin123.
After you enter your username and password, the software checks for a network connection. If you have
configured a connection, no further action is needed. If you have not configured a connection, you are prompted
for the connection information.
3. Enter y to use DHCP then press Q to continue the configuration process.
4. For a dual-server configuration using HA, enter two different IP addresses for the primary and backup servers. For
a single-server configuration without HA, enter a single IP address.
NOTE: HA is not required. However, Dell Networking strongly recommends a dual-server configuration with
HA for resiliency.
5. Enter the IP or URL for the search domain then press Q to continue the configuration.
The software checks for existing vCenter credentials. If you have configured the vCenter credentials, no further
action is needed. If you have not configured the vCenter credentials, you are prompted for the vCenter credentials.
6. Enter your vCenter credentials.
You must enter a valid vCenter URL, username, and password. For security, the password is hidden.
7. OPTIONAL: Create a new user account by creating a unique username and password.
If there are no existing accounts, the software prompts you to create a new user account.
NOTE: To confirm the password, enter it twice.
Using a Static IP
1. Start the VDS CLI session using SSH.
2. Log in using your username and password.
The default username is vadmin and the default password is vadmin123.
After you enter your username and password, the software checks for a network connection. If you have
configured a connection, no further action is needed. If you have not configured a connection, you are prompted
for the connection information.
3. Enter n to use a static host then press Q to continue the configuration process.
Configuring VDS CLI
11
(134 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales