Dell Active Fabric Manager Guía de usuario descargar pdf (Pagina 14)

– show portgroup

– show span

– show vlan

– show vlan summary

– show vlan vlan-id

– exit

• VDS mode — This mode allows you to configure the virtual switch. To enter VDS mode, use the vds command. In

VDS mode, the command prompt ends with VDS — [switch-name]#, where switch-name is the name of

the switch.

NOTE: To enter VDS mode, enter CONFIG mode, then use the vds command.

To enter VDS CONFIG mode, enter VDS mode, then use the config command.

The following commands are available in VDS CONFIG mode:

– netflow port

– netflow portgroup

– port

– portgroup

– span

– exit

• PORT mode — This mode allows you to configure the specified port. To enter PORT mode, use the port command.

In PORT mode, the command prompt ends with VDS — [switch-name]/Port— [number]#, where

switch-name is the name of the switch and number is the port number.

The following commands are available in PORT mode:

– shutdown

– exit

• PORTGROUP mode — This mode allows you to configure the specified port group. To enter PORTGROUP mode, use

the portgroup command. In PORTGROUP mode, the command prompt ends with VDS — [switch-name]/

PortGroup— [number]#, where switch-name is the name of the switch and number is the port group

number.

The following commands are available in PORTGROUP mode:

– shutdown

– exit

To use the VDS CLI:

1. Log in using your user account.

2. Enter the enable command to access the ENABLE mode commands and other command modes.

3. Enter the vds command to enter VDS mode.

4. Enter the config command to enter CONFIG mode.

Using VDS CLI

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Sin comentarios

Dell Active Fabric Manager Guía de usuario Pagina 14